Bucket Robotics

One-liner, as posted

Defect detection for molded and cast parts

42 characters (fits the 50-character limit) · uses a known reference (“X for Y”).

Excerpt

Injection molding is a process where small plastic pellets are heated - primarily by friction from an auger - and pushed into a mold - usually two big milled out chunks of aluminum or steel - that are pushed together by somewhere between 10 tons and 1000s of tons of pressure.

Short excerpt from the founders’ Launch HN post. Read the full original at the link below.

Read the launch post on Hacker News Company website

Posted 2024-08-27 · 111 points · 26 comments. Batch as stated by the founders in the post title.

More in Hardware & Robotics